[ATTACH] [ATTACH] Some more baby sled updates. Got two pieces of bottom planking epoxied on and screwed in. In the night time photo you can see...
[ATTACH] Update: I managed to cut out several of the hull planking sections and spent some time with the electric planer getting the stringers...
That’s a stout timber. Maybe do a substantial fillet to make it a bit tougher although perhaps it’s better to be a bit sacrificial sense if it’s...
I got the hull out of the shop and got it flipped over upside down so now I just need to finish epoxy coating all of the wood changing out a few...
You’re not exactly wrong… This is called dynamic pitch loss or prop flex. However, on a 40 hp outboard with the weights involved probably not the...
I may have missed some of the other comments, but typically two 40 hp are putting 80 hp out total and at a much greater weight than a single 90...
[ATTACH] Happy new year I reached the phase where I have pulled the sea sled out of the garage and I’m starting to do some different finish work...
[ATTACH] Finally Figured Out the Deck Angle – Frame Trim and Adjustments After spending a good bit of time pouring over my CAD models and the...
[ATTACH] [ATTACH] I’m not sure how many people are still following this thread, since the build has dragged on a bit—but I *am* still slowly...
These aren’t the best photos but you can see the angle of the cabin starting to lay in. Trying to get the rest of the cabin roof stringers...
I feel like with all the half used Canadian chainsaws up north… @DogCavalry could rig up several long tail mud motors as a surface drive with even...
I got some fairly good work done on the top of the cabin lots of fairing and fiberglass work there but it’s moving along at a steady clip. Big...
I wonder if the speed increase is the lack of thousands of pounds of water in the hull? I think you were alluding to that but I didn’t want to...
good points. Yea I'm almost certainly going with a Yamaha for my boat but I've been researching the outboard positioning and looking at various...
I was doing some reading and I was wondering if maybe you needed to put a 2 inch vertical by 18 inch long fin ahead of the transom to split off...
