Recent content by Danielsan

Hey you all, Wondering what would be the way to go... A friend got an OLD pre 1980 4.2L mercruiser he bought for his boat. I am helping him to install it. the previous owner had it rebuilt and put it away to use later. However the guy never continued his poject. To be sure the engine would not...

Thx for all the comments and advice, I know it seems silly these days to keep hold on these gas slurping engines but i want to bring the small boat project to it's end. Close to me I just found a reman 250 all complete with drive for 2.5k€ the guy had it overdone in a shop because its boat...

ok nice to know.... wondering why it had more hp than the straight 6 for same technology of engine... les torque for sure....

OK i trust your opinion, for my general interest why?

What about the Merc 470 is a 170hp 4 in line, where did they get the same performance as the 165?

Yeappp :(

I will need to find a new replacement parts as all has been flooded and some parts are lost in the mud like push rods, valves, other engine components will need to be replaced, starter, oil pump, crank shaft regrinded etc.... looking for some way to see if it makes sense to continue this project...

These are the V6 models I have straight in line …

It is GM as the piston ref numbers are the same as GM automotive numbers.... and the information seems to match mostly to GM

a first search doesn't give me much hits on Volvo / GM engines.... any type in mind?

Hi all, projects go slow way to slow...and in between **** hapens... I was in the process of rebuilding my my mid 70's - 165 Mercruiser this until last month my basement got flooded with water and mud ... so all engine, carb, electrical, hydraulic parts, drive etc are mosly lost... finding a 165...

haha gets confusing these imperial dimensions 0.0005" 3x 0 not 4x 0

Hi RX, unless I got mistaken or some printed specs are not ok I read ±0,0005" which is 0.0127... that corresponds to the red and green line on my graph... I ordered a 100mm caliber for my micrometer and check again...