I have been talking to a few people and they also explained a system that has a center tube that runs from front to back that sits above the...
Thanks it's a Bizzarrini P538
So I wanted asked for a efficient way to do it and Mr. Efficiency said "shortcuts are going to be hard to find" sort of ironic. I plan to take...
What is the best way to keep them spaced the same distance yet be able to change them from side to side?
What is the best way to keep them spaced the same distance yet be able to change them from side to side? Somebody should market a system that...
Thank you for the advice I agree a form would have been nice, but building it may have been more difficult than the whole project as I had very...
I am building a 1960's LeMans / Can Am car and I have built a nose out of foam. I plan to put a thin layer of fiberglass on the foam and then...
yea I thought that was weird, I am going to skip gelcoat and spray a few layers of duratec, this is less expensive, less weight and takes the...
I am currently making some car body parts without any gelcoat I plan on spraying a coat of duratec after all the glass work is done. I have...
No gelcoat as more connection work will be done later. Might give it a coat of duratec at the end prior to paint. It's for a race car and the...
I didn't know that thanks!
I am building some parts and my stack up is 1.5 CSM 1.5 CSM Knytex X-Mat 19.3 oz/sq yd laying up the two layers of CSM I wetted they up...
