I’m building one of these, you can clearly see the box below the rear beam. The sterns sit a little lower than designed but as already mentioned...
There will be many "new" things you learn building, I'd be tempted to go with the method that most appeals and learn the skills you need. A great...
Cheers, That's where I was going... more looking at clearances and angles to allow the anchor shank to come up on to the rollers and tuck away...
I like the Waller design personally, almost built one of his.... had the bigger "trailerable" cat been available at the time I would have gone...
Therin lies the problem, I'd like to not make it to specific if that makes sense..... nothing worse than needing to replace a relatively ( ;) )...
Not a Warram fan but I find the "dangerous, irresponsible" etc comments more offensive than the vague references to alleged custody dispute...
Hoping someone may have some drawings they have done around a roller setup to suit the modern anchors, on particular probably a delta. Main anchor...
So you are planning on around 2400mm above the water, in total? 30ft cat? Approx 9m beam? It would be worth having a think about where you...
Waterline to cabin top is going to give you a better idea of windage
Unfortunately the height above thehulls is meaningless,different designs have different deck/cabin arrangements. You would be better comparing...
Looking good!
What else to do when you're not at 100% other than mull over the next stages... The image shows the area I have to work with, it isn't the...
Beam image
I like the look of that rudder shaft, I was thinking of going stainless only because I haven't played with carbon and not sure I want to...