This is a diagram I did based on a 34' Sea Ray Sundancer. There are no bulkheads being removed only the deck which has 7" high windows running...
Yes, that is correct, we have all established that the hull will need to be reinforced, from the first post to the most recent, that has been the...
The Sea of Cortez, Mexico. TANSL you are clearly making a statement, so how do you propose I check this. This is what I am asking the the point...
The boat will not be being used in the US and will be replacing a 36' Panga which carries 20 pax and gear...
This could be overcome with ribs glassed into the sides of the hull. Frankly I'm not sure that the existing deck provides that much strength, it...
I am considering buying a 46" Sea Ray Express Cruiser and removing the deck from the windshield forward to make it into a very large bowrider. The...
Page 19 of the SW4024 manual: Note: The three neutral terminals are common to each other and can be used in any combination or order. In a...
In addition the neutrals of the inputs of the SW4024 are common since it wants only to switch the hots. As such regardless of which hot is...
Neutral and ground are bonded in both the gen set and inverter, if you are on shore power then you create a ground loop, will blow all the GFI's...
Phil, The issue is that the relays are not in the box. There is one single relay and it is not enough. The issue is that you can not have...
The diagram does not seem to deal with the neutral ground bonding to the ships bonding strip.
Nice sdowney717!!!! What was causing the relays to buzz? They should have been stable on 120 60hz
Thanks sdowney717, let me pencil through it. One issue I am considering is a delay circuit that will allow the gen to stabilize before switching...
http://www.defender.com/category.jsp?path=-1%7C328%7C2290035&id=2290042 The Furrion units are clearly just Dunn relays in boxes.
