Thanks Gaps on the deck to the box units are trial fit and kept to 3/8" and under between the 1 3/4" wide bottom outboard flanges with...
He has been very very helpful on other technical material questions. I have already ordered and will test 2 vinylesters so I believe I found a a...
Excellent tip and advise Thanks very much
Again, thank you very for your expert advise. I now understand why your corrected me on the futility small gun for this quantity of material and...
Thank you. 3 pails were used the same day, and those pails had the same lot number as a clarification. Your mixing comment could very well be...
Thanks a lot Gonzo. I am planning to test two Vinyl putties when they arrive Arjay 7121 @ $725 USD 5 l pail IBF 904 or 925 out of Groton CT with...
I bought some supposedly ISO poly artic white gel coat to produce a new boat als laid up using poly Iso resin in an open mold about 1.5 years ago...
Thanks
I would like some elongation to be able to also use it close to outboards where there is more vibration. I have been reinforcing poly resin paste...
I am looking for a permanent structural adhesive recommendations for gap sizes up to 1/4- 3/8". I am currently glassing and finishing these joints...
I have a 28' female mold surfaced with polyester tooling gel. The side chines are tilted upwards at 5 degrees and I would like to fill them with a...
I have never used peel ply so forgive my ignorance So you are laying down the last layer of 1708, and while still wet, wetting out the csm and...
