I purchased a marinizing kit for a V1505 in 2001 from Diecon Engineering in Australia. Poor quality image attached.
Bulbous Bow http://en.wikipedia.org/wiki/Bulbous_bow
I'm far from an expert, but wouldn't use rubber gaskets, nor phosphor bronze on a steel boat. Rubber often (always?) contains carbon which would...
Thanks Lazyjack: All hardware on the boat is unpolished cast bronze with the exception of the engine controls -- Kobelt would not sell them...
I'm building a 20' pointer style boat -- on hold the past two years because of other commitments -- and am working on a center console design. The...
Web site design I do a little amateur web site work but my designs are not very imaginative -- they all look the same! :( If any of the...
xp 64 Thanks Terry: Looks like you are correct. It's my mb that can only use 3g of RAM. The BIOS sees the 4g, but says it can only use 3. MB...
xp-64 ...and you are compiling 64-bit programs to run on it; but all/most available Windows programs are 32-bit, therefore there is no real...
xp-64 I have been using xp-64 for about a year and a half -- have not found a single advantage over 32-bit. Many vendors do not support xp-64...
1967 Akerboom (sp?) 31' X10'6" round chine steel hull with Bruynzeel mahogany cabin. Original power twin 2.3 litre British Standard Motors...
I believe that a "Rule of Thumb" for fuel consumption/horsepower is that a gas engine will generate approximately 10 HP for each gallon (US) of...