In the end I used melted lead shot. An earlier poster also mentioned lead shot and epoxy and that would have been the next next solution if I...
Another great reply. Thank you!
Thank you both for the excellent thoughts. I hadn't even thought of using an expoxy solution. The 5kg is just the amount of lead estimated to be...
I need to fill in three drill holes as well as a space where a stainless plate was located in a lead bulb. The bulb is of course currently not...
Thank you for this information. Most of it I understand (or believe I understand) but in any case it seems like I need to hit a few more manuals...
Thanks all for your replies. Yes its a bad photo. There's about a 10 - 15mm gap. There's no rot there at the moment though my shipwright treated...
24' cold-mould moulded plywood boat with many years. Needs general TLC but generally in good condition. For aesthetic reasons and for long term...
In the end I gave the 60mm sized blocks to my sister. She flew out to Fiji today to continue her traverse of the Pacific on the boat she is...
I have to admit I don't understand how friction would vary when using a different diametre line for the same sized block. I can understand though...
Thank you all for your very informative replies....learnt a few things. There will be one set of blocks (with cam cleat) at the bow and the other...
What sort of block size should be used for a davit? It's to lift an inflatable with a 5hp on the back. All up about 80kg. The blocks themselves...
PM sent - Master sailing hardware is also available through the Bombora Marine retail outlet on Ebay or by direct email order through our website...
