Tips for safe anchoring [img]
Did you galvanised your anchor? Do you have osme photo of final look?
You do not need to dive. Anchor can only set or not set. You just put engine in reverse gear and you will see if anchor is set. If anchor is...
Post some pictures with galvanized anchor. Next time, when I will travel to Turkey, I will contact you. Thank.
Nice. I like Turkey. I have been a lot of times in Turkey.
Yusuf: you need to send anchor before galvanizing it Yusuf, Where are you from?
Yes. Italy :)
I am sorry I do not speak english very well. English is not my first language. I was born in Serbia, then We move to Italy, then we move to...
Because wnen the boat pull chain, chain pull anchor and allways anchor firs turn to side and then dig inside. [img]
Veri importat part is also: [img] [img]
Like this: [IMG] Or iven beter if you bend claw [IMG] You can not bend it because is small peace and it is strong.I cuted it to help me with...
Great job. Compliments. But if you cut here claw [img] And turn claw for 180 degree and weld it again. The anchor will dig much better.
Shank= 20mm Thorn= 20mm Roll bar = 22mm Fluke = 12mm Wings (important parts welded on roll bar - not included in dwg) = 2mm
Please post photos of your project.
plate is bended four times for 150 degrees Roll bar is welded on to the plate with angle 105 degrees