Recent content by boatgm2

  1. B

    San Juan 23 as a power cruiser

    Shamrock Electric Sailboat Conversion Part 2 - Sea Trials with 72V Lithium Battery Bank
  2. B

    Plywood Fuel Tanks

    My current boat is Strip-Planked with frp inside and out. The fuel tanks are integral with the hull and the tank tops are the cabin sole. Its over 12 years old and we can ship over 1000 gallons. We used a fuel resistant coating inside the tanks, and drain, and check every few years.
  3. B

    Race Navigation

    Books - North U https://northu.com/types/books/
  4. B

    aluminum and composite hull

    thanks
  5. B

    aluminum and composite hull

    I am early in the project but like the toughness of alloy under the waterline, integral tanks and alloy equipment foundations. Somewhere above the waterline I envision an alloy channel that the composite topside panels can be bonded into. My first thoughts were to also have an alloy bow stem...
  6. B

    aluminum and composite hull

    I want to use aluminum in the hull, rubs and bow stem and composite topsides. Does anyone have experience with such?
  7. B

    USCG Stability Test for Power Trimaran

    If there a site were I can get more info on this power tri?
  8. B

    Caledonia Yawl in Thailand

    Kip, There was a project built in the Philippines that you may enjoy taking a look at. http://fusionschooner.blogspot.com/
  9. B

    Top 10 countries outside of U.S.A. or Europe to spend rest of your days aboard?

    Our home is in Guam and we keep a boat in the Philippines. We enjoy Palau and could see spending lots of time there. That said you have to look hard to find better boating then the Philippines.
  10. B

    Searching for fuel efficient powerboat

    The anchor on the bow roller of the tri is 80 lbs its normally stowage on a stern roller, the rode is lead through the bow roller. I carry four anchors, the 80lb plow , a pick , and a fortress, a parachute with chain and rodes. It’s funny to think a anchor would overload the boat -...
Back
Top