Gelshield experience anyone? It seems like the solution is to seal the existing filler with epoxy, then prime and topcoat it. My experience with...
Unfortunately I have put too much effort into fairing and finishing the hull now to go riping it all off. I am looking at coating with Interlux...
The filler used was upol extra. The boat will be afloat for a few months.
Hi. I have built a small 20ft boat using the cold moulded technique. I used polyester resin and chopped strand and roving woven. I then faired...
Thanks for the reassurance.
Using Flowcoat in Diesel Tank Hi. Looking for some advice. I have built a polyester fibreglass tank for holding diesel. I am planning on...
Hi. Am considering buying Yanmar's 6BY2-220 with the yanmar ZT350 stern drive. I believe yanmar launched this stren drive in 2008. I don't seem to...
Fairing Question Thanks for your responses. Plenty of ideas to think about. Regarding the Guide Coat, I assume that when you see an area...
Hi. I have built a 23 foot male mould hard chine boat I have just finished laminating it with 8 layers of 450 gm CSM with 417 palv resin Loyds...
Option 2 for me.