Thanks gw. I am not at home for a couple of weeks so I will check into whats needed and get back to you. Its 20 meter designed by nigel irens in...
I have to complete a MCA stability information booklet for multi hull sailing vessels for my charter trimaran. Does anyone know if this can be...
all holes were drilled oversize and have clearance to screws with washers. still cracked. some cracks are not even at screw holes. bazza
about a year ago I replaced all the window and port plastic on my boat. I contacted industrial plastics and sought there recomendations.they...
I was on a cat once that was ply with a flat bottom. for the life of me i cant remember the design. it was stitch and glue. each hull built in...
the u,line icemakers are just a freezer with an icemaker unit screwed to the evaperator. just conect up a thermostat and a water solonoid valve...
surplus center has some small new diesels at good prices.
was engineer on a large lagoon cat that ran a jackshaft about 6 feet. shaft was mounted between perkins 4108 and gearbox. had a center bearing and...
for some very different ideas on beam attatchment look up james wharram designs. very strong and cost effective.have built and owned wharram...
you dont really say if the boat will be captained or bareboated, if captained then ro is the way to go. if bareboated absolutelly definatelly not!...
dont know if these are of any interest http://www.surpluscenter.com/item.asp?UID=2006012811350904&item=16-1139&catname=water
why not. a few problems do exist though. how are you going to connect/disconect drive to and from hyd.to shaft. will gear box handle side load...
way back in the late 60s a south australian company called skippercraft made a set up that was like 2 windsurfer boards with a platform between...