Hold downs are attached to the stringers only and fit into a grove on the tank but not physically attached to it these are the hold downs that...
I have been in the process of removing my aluminum fuel tank from my boat after replacing stringers and various other items I am to the point of...
I am actually in a suburb of Chicago. If I waited till spring would it be bad to transport the boat 425 miles one way till spring with a stringer...
The original stringer has inconsistent thickness of the glass on it so I can’t figure out how many layers of 1708 cloth to use to re glass the...
As another general question how tight do you want the joints to be? Is it a tight fit like you would use in cabinet making or a bit looser so the...
From what I have been able to check the transom is good I poked around in the various mounting holes and everything was solid. The Sole was...
I have read not to directly attach the stringers to the hull but instead to tab them in and I have also read to make a peanut butter consistency...
The bulk heads were not attached to the floor. The front was touching but not attached and the rear didn’t come close to the floor it was about...
I am in the process of replacing a fuel tank in an 89 Arriva 2001 originally it was just supposed to be the fuel tank and the floor but after...
Floor is all being removed as there was some foam that was saturated with water so while I am in there I want to remove what need to come out now...
I am new to this but my general idea is to add another set of stringers to “box” in the new tank these would be spaced to allow for a 3% expansion...
I just acquired an Arriva 2001 ski boat long story short it needs a new fuel tank and before I know it I have a full blown project on my hands. I...