Sorry don't have that info. Could say more than a panga, but far less than a deep V. Everything is a compromise....
Johnny, That boat may look similar to many out there but it is not. I had a run on it and it ran very differently to any number of deep V boats....
This comes to mind and kicks a few of your goals. Modern stitch and glue build...panga inspired but not a panga.... Uses a few tricks as...
Good Luck!
You have a very small gap (4.6mm long) between near the "gunwale" area port and stb essentially making it impossible to trim. Check for naked...
As long as the object is supported at the same points you are measuring the loads at that would work. ie boat supported only at bow and stern,...
Get hold of a load cell or scale. Can be hired in most places. Have used them many times for boats up to about 50' Just need to get them under...
conflict??????
Simple answer: yes. Converting file formats is a pretty normal occurrence. Provided you repect the IP then no foul. More extended answer: You...
I did lose the wingnuts, but they don't fall over any more. I put screws through the plate from the underside... :) Painfull things. I...
Yes you have given some rough dimensions, but not enough for a detailed engineering analysis.....I am sorry I only skimmed across them, but I did...
Saying that people don't have any clue when they talk about solid stocks is a pretty big call when 99.99% of the worlds boats have them. Using...
Just build a complete new one if you are happy with how that one has held up over time. Take a bunch of measurements and templates of the...
ok, sounds like I might have what you are looking for. Send me your email address via pm, and I will reply.
Preferred material? I may have something here...
