hi can any one help lookin for pics ,plans etc of small mono as used in uk j 250 class to build own boat to same spec all out of wood or glass...
jet boat wow if only i could afford shipping cost,thank you great find taaaaaa lord ,it loooks great fun but i need to have a mono only 9 foot...
thrower hello john, a thrower is only a rubber washer to divert water away fom shaft with centrifugal force ,spinning water in this case off the...
do it all with hydraulics one engine two props or two engines one prop shaft with variable prop, nice installation put any where,if use very...
also check connection on elec stop soleniod if got one fitted you will find on injector pump, also completely undo a injector pipe next to...
hi it sounds like you have a fuel problem with suction /vacum poss make sure u can bleed fuel freely from palm pump on engine to nearest bleed...
hi there ,diazklm if u mean ultraflex ,then undo cover if fitted round hub ,then below that should be a 7/8 22mm hex nut ,undo but not complete...
hi 2 wooods, well, raw water should come from a filtered source,then into gear box cooler ,if have one ,then oil cooler for main engine ,then...
hi guys ,i ve seen spray rails from the edge of the chine to middle of keel spaced out of course,instead of being flat they have been quite deep...
ford 1600 hi ,there i have had lots of exp with this engine ,is the raw water pump mounted at front of engine being driven by the camshaft??? ,if...
and so thanks guys ,thanks for all info , i m hoping to run 70hp motor turnig out about 90 hp after tinkering ,boat is about 14 feet circuit...
hi guys thanks for great info so far,my next tech question is which is more suited to my needs for short power boat racing (circuit in uk)on a 16...
what are the advantages of having a ski bottom on race /ski boat, compared to solid vee to full length of hull also is it worth having...