Underwater LED Light Install

Discussion in 'Fiberglass and Composite Boat Building' started by silvah, Nov 15, 2017.

  1. silvah
    Joined: Jan 2017
    Posts: 18
    Likes: 0, Points: 1, Legacy Rep: 10
    Location: Oconomowoc, WI

    silvah Junior Member

    I am looking for some feedback on installing some LED underwater boat lights. All of these lights require a hole drilled through the hull. The installations that I have seen demonstrated on YouTube are all on fiberglass hulls, where there would not be any issues related to core damage due to leakage.

    My question is what should be done on a cored hull, either plywood or foam? I feel like following the Gougeon method, of drilling a larger hole than is required, backfilling with epoxy, and then drilling the hole the correct size is the way to go here to insure there is no possibility of some sort of water leaking around this light causing the hull to rot. Thoughts?

    It seems like all of the installations are using 3M 4200 marine sealant. Would you trust that?

    Thanks!
     
  2. Blueknarr
    Joined: Aug 2017
    Posts: 1,449
    Likes: 412, Points: 83
    Location: Colorado

    Blueknarr Senior Member


    You are on a good plan.

    I would consider doing the filling from the inside to take advantage of the gravitational assist instead of fighting it from the outside.

    Paul
     
  3. silvah
    Joined: Jan 2017
    Posts: 18
    Likes: 0, Points: 1, Legacy Rep: 10
    Location: Oconomowoc, WI

    silvah Junior Member

    Thanks Paul, these were my thoughts exactly. They make the installs look so easy and I suppose they are when you don't have to worry about saturated core materials. In the case of the sealant failing on a fiberglass hull you just get some water in your bilge, and you have your alert the seal has failed. With a core you could have a major repair in store if you don't go through the hull correctly.

    I just don't trust these silicone sealants. I know there in wide use now days, but I have my doubts none the less. Has anyone done an install and had the silicone fail after a while?
     

  4. pauloman
    Joined: Jun 2010
    Posts: 268
    Likes: 10, Points: 18, Legacy Rep: 151
    Location: New Hampshire

    pauloman Epoxy Vendor

    use a kevlar thckened epoxy paste to fill the hole. If you grease your bolts or screws with grease you can remove them when the epoxy sets up and have a perfectly threaded hole.... see wet dry 700 epoxy
     
Loading...
Similar Threads
  1. abosely
    Replies:
    8
    Views:
    1,197
  2. mudflap
    Replies:
    8
    Views:
    1,492
  3. Darkzillicon
    Replies:
    145
    Views:
    15,024
  4. DogCavalry
    Replies:
    2,996
    Views:
    182,759
  5. capD
    Replies:
    1
    Views:
    983
  6. aaronhl
    Replies:
    20
    Views:
    8,780
  7. Skua
    Replies:
    0
    Views:
    1,713
  8. pescaloco
    Replies:
    11
    Views:
    4,262
  9. Ctowles
    Replies:
    8
    Views:
    3,305
  10. rwatson
    Replies:
    0
    Views:
    1,998
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.