most seaworthy trailer sailboat?

Discussion in 'Sailboats' started by mr curious, Oct 15, 2008.

  1. mr curious
    Joined: Jul 2008
    Posts: 94
    Likes: 1, Points: 0, Legacy Rep: 20
    Location: BC Canada

    mr curious gunkholer supreme

    well?

    is there such a thing?

    :?: cheers :)
     
  2. PAR
    Joined: Nov 2003
    Posts: 19,126
    Likes: 498, Points: 93, Legacy Rep: 3967
    Location: Eustis, FL

    PAR Yacht Designer/Builder

    Flica on the small end of the scale, with several at the large end (30'). No, there isn't any such thing, just some that are better then others and personal preferences.
     
  3. alan white
    Joined: Mar 2007
    Posts: 3,730
    Likes: 123, Points: 0, Legacy Rep: 1404
    Location: maine

    alan white Senior Member

    How about a St Pierre dory? 27 feet and very trailerable. Some say that there is no record of lives lost due to any design fault. It's probably an exaggeration, but such dories and smaller ones have gone transatlantic over 100 years ago. From all I've heard, the high ends and angled sides contribute to a boat that refuses to be tripped by waves.
    A reasonably well ballasted banks type dory could probably go anywhere, especially if the cockpit is self-baling and the cabin is low.
    The downside is that dories with slab sides make slow sailers.
    I've often wondered if an additional chine or two (like Swampscott dories) would improve the sailing qualities while maintaining the survivability of the original type.
     
  4. fcfc
    Joined: Feb 2005
    Posts: 781
    Likes: 29, Points: 28, Legacy Rep: 399
    Location: france,europe

    fcfc Senior Member

    Perhaps look at minitransat style boats : http://www.pogostructures.com/?m=2&s=1&l=

    They are the smallest offshore racing boats. They can go in any direction in a 40 knot wind 13 ft waves, including upwind with an acceptable speed. Thats about the upper limit, though. Above that, weakest crew/boats begin to have problems. They also regulary cross Atlantic. Being the cheapest offshore boat, they are numerous enough to make reasonable statistics.

    Trailerability is possible, but borderline. 22 ft lengh and 2000 lbs displacement do it. 10 ft beam is more complex. Either use an overwidth permit, or use a special slanted trailer, to make the whole width within 8'2". Draft is another issue 5'5". Some have removable keel, something between liftable keel and fixed keel. Definitely not able to use ramps.
    NB to go upwind in 40 kt wind, you need significant draft and significant ballast well down.
     
  5. Petros
    Joined: Oct 2007
    Posts: 2,934
    Likes: 148, Points: 63, Legacy Rep: 1593
    Location: Arlington, WA-USA

    Petros Senior Member

    I do not exactly know what you mean by "most seaworthy" but these guys make a high performance folding trimarans up to 44 ft long that can be trailered.

    They look like hot designs:

    http://www.f-boat.com/pages/trimarans/index.html

    And this outfit makes a large trailerable catamaran 36 ft long x 24 ft beam, that folds to 8' 6" wide:

    http://www.cat2fold.com/
     
  6. Hansen Aerosprt
    Joined: Mar 2007
    Posts: 62
    Likes: 0, Points: 0, Legacy Rep: 29
    Location: SF Bay

    Hansen Aerosprt Junior Member

  7. schakel
    Joined: Jul 2008
    Posts: 386
    Likes: 16, Points: 18, Legacy Rep: 48
    Location: the netherlands

    schakel environmental project Msc

    beautiful

    Beautiful,

    That's where I am looking for for a long time. One problem: trailing it from the USA to Holland. But I keep on searching.
     
  8. K4s
    Joined: Nov 2004
    Posts: 68
    Likes: 2, Points: 0, Legacy Rep: 29
    Location: New Zealand

    K4s Junior Member

    Allan Wright designed the TASMAN 20 for a bloke who wanted a 20 foot trailer boat he could sail from NZ to Fiji safely(relative I guess).
    Hundreds of them sailing around NZ and quite a few for sale on Trade me down this way.
     
  9. blackdaisies
    Joined: Sep 2008
    Posts: 136
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Tennessee

    blackdaisies Senior Member

  10. Steam Flyer
    Joined: Aug 2008
    Posts: 31
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: North Carolina, USA

    Steam Flyer Junior Member


    I love the look of the Cornish Crabber and the Selway Fisher gaff cutter designs; Dudley DIx did the same sort of thing with his Cape Cutter
    http://www.dixdesign.com/inspir19.htm

    But there's a difference between looking salty and truly being seaworthy. These boats could be very seaworthy, but what are the main characteristics, and how do you achieve it in a boat that is also trailerable? Obviously making it very heavy, or giving it very deep draft, which are usually characteristics of "very seaworthy" boats, is not desirable.

    I would say to be "seaworthy" a boat needs a couple of characteristics... the first is reserve stability. This means the ability to recover from being knocked down or rolled on (or past) her beam. This will also enable the boat to remain manageable and carry sail past the point other boats with more initial stability would.

    Second (and not less important) is watertight integrity. This is partially design, partially construction, and will to some extent depend on good maintenance thru her sailing life. Watertight integerity keeps you afloat and it also keeps your gear & bedding dry.

    Obviously lots of different type boats can do this.

    I like the St Pierre dory idea. A long history of seaworthy boats there, and no reason it wouldn't be trailerable.

    Another similar is Bolger's Micro, a bit small at 16' so you could do the Big Micro 19'.
    http://www.boatdesign.com/micro/

    FB- Doug
     
  11. zambant
    Joined: Oct 2008
    Posts: 3
    Likes: 0, Points: 0, Legacy Rep: 10
    Location: Southampton

    zambant New Member

    Take your pick

    But you could do a lot worse than a Jaguar 22 .... the old ones were built like tanks, sailed well, trailerable, displacement about 1200kg and can be picked up for relatively little money..

    My 10p worth

    John
     
  12. bistros

    bistros Previous Member

    St. Pierre et MIquelon dories are really interesting. They often had u-joints on the propeller shaft outside the hull, and the whole prop could pull up into a well. They were traditionally beach launched off tracked ways and a cradle outside the owner's fish stage. Craftsmanship was more important than their Newfoundland cousins - since they were beach launched they didn't have the luxury of taking up water to seal seams that boats left in the water did. Lots of these boats were used for smuggling rum during prohibition.

    The original make and break single cylinder engines were an art form with serious personality as well - by lifting the spark wire and re-connecting it as the right time, you could reverse the engine. There was no predicting whether or not you got it right until you could see shaft rotation direction.

    --
    Bill
     
  13. mr curious
    Joined: Jul 2008
    Posts: 94
    Likes: 1, Points: 0, Legacy Rep: 20
    Location: BC Canada

    mr curious gunkholer supreme

    thanks for the feedback guys, very interesting.

    :)
     
  14. mattotoole
    Joined: Nov 2004
    Posts: 200
    Likes: 1, Points: 0, Legacy Rep: 13
    Location: Potomac MD, USA

    mattotoole Senior Member

    Some other boats like the ones mentioned:
    • Nor'sea 27
    • Pacific Seacraft Flicka 20 and Dana 24
    • Folkboat and Contessa 26
    • Cape Dories less than 28'
    • Chuck Paine's Frances
    But while these have trailerable dimensions (length by width by height), they're all pretty heavy, and would need a monster truck to pull them. They're not really ramp-launchable either.

    For a more normal tow vehicle and ramp, you might check out the S2 7.9, a Great Lakes favorite. In the same vein, but bigger, the new Andrews 28 looks great.
     

  15. Chickadee
    Joined: Jul 2005
    Posts: 88
    Likes: 5, Points: 0, Legacy Rep: 78
    Location: Europe

    Chickadee Junior Member

    what is your program ?

    26's Contessa and Ocean Voyager are really big looking like the real - but tiny - classic cruiser !

    On the other side, the Pogo is a big boat too, maybe be more seaworthy - do you discuss it ? - and it goes so well! but it's not trailerable, you'd need to ask for a special permit as even with a special slanted trailer it would be more than 2,5 meters I believe. or unmount, then remount the keel, 430 kg ?!

    Older minitransat have circumnavigated and are trailerable, with big cars only

    So a true trailerable sailboat is a day cruising, lighter boat, no need for a lifting crane.

    Plenty of nice, day cruising, old looking boats in the previous posts !

    Or look at the Microcup for somethin more modern and performant. Cute isn't it ? Or multihulls, people have crossed the atlantic on hobby-cat...
     
Loading...
Forum posts represent the experience, opinion, and view of individual users. Boat Design Net does not necessarily endorse nor share the view of each individual post.
When making potentially dangerous or financial decisions, always employ and consult appropriate professionals. Your circumstances or experience may be different.