I have a 19' x 95" v bottom boat that tends to be very wet if I am quartering into the waves. the sides are 90 degree to the waterline. I...
My power t/t quit working! At first I thought it was a low battery because it was slow moving but after charging and running the boat it has...
I looked and the owner manual again and again - if I am reading it correctly the outdrive uses 10w/40 oil just like the motor. I expected it to...
I am trying to get an older VolvoPenta engine running again. The water pump has a bad seal and needs to be replaced. When I look on the...
I have a 99 50hp Johnson on the back of a 19' boat. It will run the boat at ~ 24mph but it does not have enough power to lift the bow if someone...
I bought a boat several months back and the paint is flaking off in places. It does not look like the aluminum was sanded prior to painting. The...
I am wanting to start learning to weld aluminum. How much (ballpark) will it cost to get started. I have a cheap MIG welder that I used to...
What is the proper way to fix spider cracks in jell coat on a fiberglass boat? These cracks are along the cabin section and not in structural...
Is there any information out there on designing and building “small” boats in aluminum? The books I have found consider anything 25 - 50’ to be...
After doing a lot of looking at production boats and not liking what I see, I have started thinking about building one on my own (with the...