Thanks for the idea. I will look at doing that as well. My big issue right now is finding someone to do the welding/fabracation. It is not...
Are there any other companies that make a product like SMART-RAIL? SMART-RAIL Model M-2000 seems to be the answer to my wet ride issue but at...
I think it was an attempt to copy a Reverse Tunnel Chine from a different brand (fiberglass) in an aluminum boat. The other builders comment on...
I'm think it was a anti-spray attempt. The boat is stable.
Here are some photos of what the builder did on a later version of my hull. I have been told that the ride in this boat is dry. the reverse...
so are you saying that if I did what the original drawing had but at a 4degree angle down it would fix the issue? More like this: [IMG] I...
Moving the consol forward is not an option without a good deal of metal work as there is a bench running the full length of the side. From...
I have a 19' x 95" v bottom boat that tends to be very wet if I am quartering into the waves. the sides are 90 degree to the waterline. I...
After the bump, I can not hear anything.
My power t/t quit working! At first I thought it was a low battery because it was slow moving but after charging and running the boat it has...
thanks, I just wanted to make SURE!!!
it is a 270 attached to a AQ125B.
lloyd, take it from another duck hunter, unless you are hunting VERY small ponds and creeks that boat is to small. adding the pods to the back...
I looked and the owner manual again and again - if I am reading it correctly the outdrive uses 10w/40 oil just like the motor. I expected it to...
After a call to VolvoPenta they have updated the price to $260. I have NAPA ordering 2 different ones to see if they match. Gonzo, I'm sure...
I am trying to get an older VolvoPenta engine running again. The water pump has a bad seal and needs to be replaced. When I look on the...
I have a 99 50hp Johnson on the back of a 19' boat. It will run the boat at ~ 24mph but it does not have enough power to lift the bow if someone...
I bought a boat several months back and the paint is flaking off in places. It does not look like the aluminum was sanded prior to painting. The...
I am wanting to start learning to weld aluminum. How much (ballpark) will it cost to get started. I have a cheap MIG welder that I used to...
What is the proper way to fix spider cracks in jell coat on a fiberglass boat? These cracks are along the cabin section and not in structural...