Ok, you seem to have a good grasp of the problem and solution. From the description given by ondarvr, the slow cure at the surface is consistent...
I would consider looking at two separate problems. First, you need to hire something to get the trailer to the site. Second, you need a much...
Yes, I basically agree with you. Mostly clickbait, but perhaps there was some substance. I had hoped that someone might point out where to apply...
This appears to have come out in May of this year, so I doubt it has been used. I was fishing for links when you posted this, so I didn't see your...
This is a little rough. Approximately 38 to 53 microns. So says a clickbait article from Wired. Distributed Micro-Roughness (DMR) is not riblet...
The first quote about area ratios is true when you are looking at materials that are anodic to C by more than a few tenths of a volt and are not...
Using stainless or titanium in contact with aluminum is always a challenge. The the more noble metal has to be isolated as much as possible from...
Citric acid is a good chelating agent and is hard to beat for removing rust without removing much base metal. In this video, 100g of citric acid...
I will accept the argument that while a waterlogged block of EPS can dry out given free flowing dry air and a favorable surface area to volume...
Jan 1 registration? So this is a day late and a dollar short. But the website says "Registration is open until Friday, July 24, 2026". Fills up...
Those tests are usually 24 hour immersion and say very little about long term absorption. Surprisingly, the short term water absorption of EPS and...
Corrosion of Metal in Wood Products has a good description of nail sickness and similar testing in pressure treated wood to that in jehardiman's...
I certainly hope you don't fit the profile. They have a lot of contacts in the area and might be able to put you in touch with someone who wants...
In DC, the first place I would ask is Home | Alexandria Seaport Foundation https://alexandriaseaport.org/. I would think that you would do better...
Stock Hemisphere Molds - Crossman Manufacturing https://www.crossmanmfg.com/stock-hemisphere-molds/ 60” Dia x 30.000” Deep FM60
If you want 30 mph from 25 hp and a dead simple plywood build for short money, why not a Bolger Diablo? It would be easier than modifying a jon...
Any answer to the question depends on the permeability of the vapor barrier, the temperature ranges, desiccant used and humidity variations over...
Warning TLDR and not exactly on topic, You are free to skip to the next post. It sounds like you might be able to count the rings per inch (or mm...
Paulownia doesn't always demonstrate much resistance to decay. It may, like a number of other woods depend on the age of the tree and the location...
It may have been be possible to make a developable surface in the forward end of the tunnel. This is not to criticize, but to warn anyone...
