After all of the fine calculating we add a safety factor of four or five, and then go to the next size commercially available components.
Levi. The ones I use draw .8 watts and move 24 CFM. Six years now on the originals and still running .
Levi, There seem to be more ways to spell Bel Air than there are places with the name. Just for fun see how many sentences you can come up with...
Levi we have Talked in the past. Bel Air isn't as cold today as it was last week and not as cold as the forecast gives us for next week. Life...
In cold weather kerosine doesn't gell as readily as #2 diesel. A lot of farmers add kerosine to their diesel fuel in the winter time.
I have a favor to ask of all boat owners that have had repairs made to sail covers, biminis, dodgers and the like. I have a friend that is a...
Granted.:)
When I needed a fiberglass tube I wrapped waxed paper around a tube of the correct size and glassed over that. The biggest problem that I...
Assuming that you are not building a single ply panel you can but the cloth in each ply and stagger your joints so that you over lap each joint...
Polyester resin bonds to PVC very well. Epoxy won't bond at all. Just get a piece of pvc pipe and lay a piece of glass cloth on it with some resin...
A very good reason not to use it(vinegar).
Freezing just delays the cure. you may even place the unused portion of your mixed epoxy in the freezer to delay the cure.
When you have an empty can, mark it "used" and when you clean a brush pour the solvent into the "used" can. Then next time use the dirty solvent...
Not a problem at all. It is white because you have worked a lot of air into it and created a foam. Just as soapsuds are not as runny as soapy...
While all of the answers that have been posted are valid, Denatured Alcohol, AKA stove fuel, will clean uncured epoxy from brushes and almost...
That damage appears to me to be the result of the wood getting wet and swelling. Measure a dry piece (same species)as thick as your example....
One of the problems that plague projects like this is sharp corners. Use your router and round all of the edges to a minimum 3/8 inch radius. Then...
Starting with insufficient engineering knowledge would be the worst mistake that you could make.
Check out coreplank it is made by CoreCell, It is two inch wide cove and bead strips made for building boats from moulds just as you would build a...