Want to mount a rear transducer on my wooden/painted skiff. Thinking a mounting plate a good idea. So, how to mount the plate…..guess I could...
Well I’m down to the seating... would like to use a series of slats. The question is... is there an industry standard for overhang and spacing?...
Ply on frame …14 foot…9.9 hp outboard. I’m about to finish this thing up.was all set with the transom for short shaft. Well, low and behold a...
Ply on frame…edge tape and two 6 oz cloth. Bottom weave is filled and peel p,y over epoxy with some low density filler. Decided to use a...
Fiberglass on ply. Two 6 oz fabric epoxy to ply. So….time to fill the weave. Would like to fill the weave and top off with peel ply. My main...
Any opinions on a hull fiberglass schedule on a wood skiff. Bottom vs sides first? 50” cloth is perfect to cover the bottom in one run. Then 1/2...
2 layers tape on seams. Will be unable to put fiberglass on hull within reasonable time. So, the question centers on preparing the epoxied seam...
Ply on frame, 1/4” ply, 2-6 oz cloth, 2-4” seam tape. Should the cloth still overlap the seam tape If I put the tape on first and offset the edges...
1/4” ply on frame…recommended 2 layers 6 oz cloth. Pretty straightforward. 6 oz plain weave = .0093 8.5 oz 2x2 twill = .0096 8.5 oz 8 harness...
Constructing a ply on frame skiff. Stem is SYP. Keelson attaches to the base of the stem…so in essence the stem sits on the Keelson. Plans...
Ply on frame to be used in the marsh in southern Georgia. Lots of oyster shell banks. Now, these shell banks are in shallow water so should not be...
Planning a small skiff to fish shallow water. Lots of oyster bars. Concerned the one coat glass and epoxy won’t hold up to the scrapping....