Finished product for now(I’m gonna wait till I re-sand and paint till the end of the season)
Thank you, you have the science nailed down to a T .I just mounted it,I will wait till the end of the season before I lay another coat.
After a long bout with regret And thinking I could have painted the box a little better since the outside of the box was sanded down to perfection...
I go there every year. I love it up there.
I’m getting itchy to catch some stripers,I think I have to re-sand this box,it does not look up to standards.My epoxy, glass and fairing sanding...
That board goes down 4-5 inches. Although it is not structural I would like to at least seal the whole perimeter, since it will be an open wound....
It looks like the wood delaminated from the glass and the wood is dry rot.The new box is to be mounted to the side walls of the opening , that...
My Gel coat surrounding the box is dull so time will make both the box and gel coat look as one.
I have primed/then sanded...it went well till I laid down the paint(roll and tip)I had numerous debris embedded in the paint.I think this is where...
Thank You, you always pull me back to patience.I started a coat of resin.I read on another thread that microballoons retain water.I respect your...
I guess the 407 has micro balloons and these balloons absorb moisture?that is why they suggest the epoxy?If I would have known this I would have...
16 years ago I used git rot on my transom I laid down a few coats before glass...But I sanded it smooth and noticed it did not Penetrate too...
It was the bottom of the old access panel I removed
Fairing Question, I am using west system fairing.The video on YouTube says after sanding, Apply several layers of epoxy. The tube of 407 says sand...
Ok 4200 it is, thank you
I used fast epoxy from west system that has a working temp of 40 degrees.Since I hope this worked in my favor.I would have Liked to go with the...
So, I took off the old access panel and noticed the wood on the bottom portion of the door is soft:rotten. Can I drill a few holes like git rot...
I have read the book; it is a little difficult trying to absorb and apply all of the info without messing up. I'm trying to rush a little bit I...
So you don’t recommend 5200 at all? Even if it was used to caulk the perimeter? If the 5200 is in an accessible area like a perimeter I should be...
