Is it likely to be sprayed chop strand? The only reason I ask is that it was made in 1969. The underside seems to be around 8 to 10mm thick and...
It was in a locker originally, so out of sight. However, the whole inside of the hull including the coach roof appears to have the same coating....
I have checked the thickness from the surface of the 'white coating' to the amber below and it is upto 3 to 4mm in places. I can't see any roving,...
Thanks for your reply. I will try that tomorrow. So in hindsight I may actually have been correct in sanding back the inside of the hull until I...
That's a fair point to say that they could have pooled, but is this likely on a vertical face? What sort of thicknesses are common for flowcoat?
Yes that is what I'm saying, because I can see the glass textured fibres, but also the thickness seems too great for flowcoat. Does pigmented...
Hi there I am currently looking to replace a couple of the bulkheads onboard a 31' motor cruiser. I started to sand down the inside of the hull...
Thanks ondarvr, I will look tomorrow at the best course of action
Hi I have repaired some old skin fitting holes above the waterline with polyester resin and csm, but some of them have finished maybe just a bit...
