Hi all As I wrote in an earlier post I am building a motor bed this summer. I am now curious if there are alternatives to lamination. Is it...
Dear knowledgable forum I am installing a 10hp volvo penta in my sailboat. It was made in 2005 and I am guessing the rubber motor mounts are of...
Hello I have a 3 metric tonne 29 ft sailboat with fin keel, quite easilly driven. I am installing a 10hp Volvo Penta in it (I know, weak, but I...
As some of you have seen in my other posts; I am installing a Volvo Penta 2010 in a 29 ft sailboat. Now I need to build an engine bed. I have...
Together with an engine that I just picked up, there is a shaft coupling, which I'm guessing is an old design. Most modern couplings that I see...
Hello all I am choosing between two flexible couplings for my new engine installation. It's a 10hp Volvo diesel going into a 29 ft sailboat that...
I am rebuilding the inside of a 29 foot grp sailboat. After I have installed bulkheads I will add insulation to the inside of the hull, which is...
Dear forum I am rebuilding the cockpit sole in my 29 ft sailboat and have come to the installation of new self draining. The entire sole is new,...
Hello I am building two mast supports to be screwed to the main bulkhead of my 29ft fiberglass sailboat. They are plain horizontal beams, 6x8 cm...
Hi all I am installing a water based (?) heater on my boat, have used it before and like it. It pumps kerosene heated mixture of water and...
Hi everyone I am converting a 29ft sailboat to electric, as part of a renovation. The choice of motor, voltage, type pf current etcetera is a big...