Nick and Jesse would be disappointed.
Just about anyone from Canada knows this boat. The "Beachcombers" television program was on for over 20 years. The Persephone has been restored...
I am sure many of you are aware of this contest. I think this is a great competition and look forward to the results. Anyone know when the winner...
Paddle wheel Thanks for sharing your knowledge and experience. There is no doubt that sometimes the old designs are best in their simplicity. I...
Do two independently driven stern wheels offer a significant advantage in steering? And if so, is there an issue of synchronization ? I was...
Thanks again for your reply. I was quoted $7279.00 for the Scott 751 pump. Nice units, but, I can't justify the cost When I can buy an Opti 200...
Thanks for your reply. I checked into the At- 309 pumps And their impeller chart starts at 150 h.p.The fellow I talked to recommended a "c" cut...
I am looking for a jet pump to match an engine 130 H.P. /120 Ft. - lbs. torque at 6000 rpm w.o.t. The boat it will go in will be 1300 lbs....
Thanks very much Ike. Your site is very informative. I just picked up the new WoodenBoat and read the article profiling Dick Pulsifer and other...
I would be interested to hear the advise and experience of those involved in building and selling boats. Notwithstanding building to the governing...
Is anyone using a power bead roller to form spray rails ( side stiffeners ) and or keels and rubrails in 1/8" aluminum sheets? I inquired with a...
Can anyone tell me if a 703 side mount control works with my Yamaha 40 jet? I found one new in the box on craigslist. I am guessing you use an...
Thanks again, it might be a while.
20 years. I have built this boat. I just want to learn how to design what I already know is achievable. If I could design as well as I can work...
Rick, I am trying to design a jon boat style skiff with jet tunnel for my Yamaha jet outboard. I would like to use a 54" wide bottom 16 Ft. loa....
Got it now. Thanks
I am going thru the tutorial that uses a scanned linesplan. I would like to use this one but its pointing the wrong way. Is there any way to flip...
I downloaded Delftship this morning. A lot to learn. Perhaps an old dog can learn new tricks. Thanks again
Thanks Rick. I can't seem to open your attachment. Can you tell me which program will open the file?
The attachment is for the bottom sheet of a 16 ft. skiff with a 54" bottom ,6 degree deadrise to midship transitioning to a 12 degree bow entry....