With 30 in draft and a 2GM20F engine it should be a good conversion. I've added an additional fuel and water tanks to increase it's range to...
I've installed dingy davits, motor davit and propane. I'm holding off on bottom paint until I get a launch date. At 26 feet this boat has the...
Building is almost complete. I finished striping and putting the name and homeport on each side.
Just installed my fabricated windshield. Doesn't look too bad.
26 ft S2 8.0 center cockpit. Building into trawler. Should be ready for a Northern run the second week in April. Added 2GMF20, 50 gallons fuel...
I've almost scraped all the barnacles off the bottom. I do alittle at a time. I'll launch her in mid April for a cruise to the Chesapeake.
I've run the engine a Yanmar 2gmf20 for over an hour so far. I put in a new electrical panel. All the ac and dc systems are in. I'm waiting for...
The IP is not in poor condition. It's also not what I would call a possibility for a pocket trawler. The little S2 is easier to trailer and...
I'm replacing the old ysb8. It still runs good. Island Packet and motor for sale Daytona beach craigslist boats and parts. Boat already has...
That's a nice job you did on yours. I have a 31 ft 1984 Island Packet I've been trying to sell for over six months. It has no mast, rigging or...
I've pulled and repaired the rudder and have half the hull scraped. I need now to pull the USB8 Yanmar engine and sell. I have also set the 1in...
I drove down to Marathon Key yesterday and bought a Yanmar 2GMF20 for 500 dollars. It was submerged for some time. I'll rebuild it and install...
1978 8.0 S2 center cockpit. Will try to convert to pocket trawler.
Well I got the boat home and started working on removing all the barnacles. I have already repaired the rudder and need to reseal the rudder...
Yes, it is the 8.0 C model. I'll most likely pull the current motor YSB 8 and install a 2 GMF. Increase the fuel and water capacities. Install...
I've just purchased an S2 26 ft center cockpit sailboat. I believe I can make a trawler from it. It is full displacement, 30 inch draft, with a...