If you wanted to glass a rebate into an (already existing panel) to allow for a flush fitting window, how would you go about it? I have some...
Quick question, can't find a definitive answer. I know some boats have the first layer of the hull skin as vinyl ester & the rest as polyester....
I'm looking for some advice on how to tackle this repair to the floors that stiffen the bottom of my 28' sailing boat around the keel area. Post...
On most boats you'll see a lot of cut outs in the deck / cabin sides / cockpit / coamings etc. For windows / instruments / hatches / hardware etc....
I have a chain-plate relocation project ongoing. The laminating schedule I have from the designer specifies 7 layers of 600gm biax in epoxy for...
Pretty simple question as per the title, if only the answer was the same! So I realise this has been done to death and right now my eye are going...
As per the title. Pretty standard setup, single spreader 7/8ths swept fractional rig, shrouds to the deck, tie bar to the hull. The problem I...
Good afternoon. I'm looking to get some advice around renewing the gelcoat on the non skid of my deck also on the non skid areas around the...