SC, Phil and RB. Thanks for these very interesting ideas/suggestions. I'll check them out very soon. I'm a little under the weather at the moment...
Well there you go RangeB, I knew I read it somewhere... Just joking! I looked at it on a bookstore years ago, but went with 'Bury my heart at...
Hi Will Sorry but I was writing ;-) All I can say is that I sailed around the world in a hard chined sailboat and at sundowners, many people said...
Thanks for your replies guys. You're both clearly thinking along the same lines, where as I was thinking to reduce the volume. If you view the...
I have the offsets and lines plan. The problem is I have very little space. I have enough room to loft the frames from the offsets, but only just....
Mr E Simpler, Quicker, less potential distortion, (3mm plate) Easier on my bad knees during construction, stiffer and less roll at anchor. But...
Happy 2021 to all! I'd like to convert an existing plan from Multi-chine to Hard chine (single chine) I've built several multi/radius and hard...
Sorry, a hiccup in my memory. I was thinking of Dudley Dix. Yes, Unfortunately, Denis and his wife were killed in a car wreck. His daughter -...
Hello again. [MEDIA] Please see the video link above for another idea how to roll a composite hull. This is just a clip I copied from you tube....
A light truck hydraulic jack and the jack out of my landcruiser. I've also used railroad jacks in the past. (mechanical ratchet jacks - sometimes...
Hi... New poster here! I've been lurking for years, but as I'll be looking for some design advice shortly. I thought a bit of participation was...