Look up jonathan Glasser. He’s on the east cost. He might be willing to do a project like that.
i find its insulation and heat deflection properties very interesting. the biggest reason you don't see a lot of boats being made from it is its...
offering $20/hr full time and i will pick up the house rental. if you have experience with infusion, i would like to keep you for 2-3 months.
I'm looking for some help to finish out a deck plug and hatch plugs. Then lam the mold off of it. Located in Albany, Georgia (USA) help is needed...
The pressurized accuspray gun will push out just about anything. I just finished spraying a 18ft skiff plug with duratech base primer. Basically...
@TheTikiGod look up young boats. Their 17 should check all your boxes
@TheTikiGod email him and ask him. hi probably knows someone that will. being in the same predicament but I like to pole, he helped me modify one...
Do you plan on poling or just use a trolling motor? You can contact Chris morejohn and I know he has a few designs for big guy skiffs that you...
These are the outside lines. They do not show the fillets that would be placed to round the corners. My stations are on 18in centers. If I didn’t...
[ATTACH] [ATTACH] Here’s two examples of what I have done. I can have one of my detailers put them in a 2d cad if that helps
I don’t have any cad software. I’m a structural steel fabricator by trade. Chris morejohn gave me his marquesa hull lines which I drew out full...
im in the drafting phase of an 18ft poling skiff and need some help with the step placement and design. I have stations drawn and in pdf. Who can...
Winter time yes. Direct sun in South Georgia summer at 95* I dont know. With my 23’ bay i got lazy and used a wooly pad on my buffer to remove it...
I’ve had good success with the 3m marine ultra wax. I always use a hard wax 2x a year, and when I use my foam cannon to wash my boat down after I...
Cover it 100% with sand. Depending on how big your part is, that can be done in a bucket, barrell, or for large pieces... in a hole but then a...
3rd gen fabricator/ AWS cert inspector here. Joined just to answer this conundrum. Anytime you quench a weld and the base materials, you are...