As im gluing in the outer skins for my battery trays and transom this weekemd and fairing in the gaps with thickened epoxy resin it hits me...how...
Not sure if your repair is holding up, if you make your living doing this id get a spare! There is a place near Atlanta ga called lanier marine...
Couldn't find a whole lot of info on this outside the car guys. People are using 351 headers/manifolds on LS engines. One hole needs to be...
Ok so may do a test batch when i pour my last stinger on furr or white pine. I dont need a lot of structure on the swim platfrom but i can't have...
i will run a test batch. Driving @ the 15th to get 10 more gallons. My stingers and transom are solid arjay. The swim platform will be a combo...
Im the midst of repairing stingers, motor mounts and other rotten wood in a 23 ft cabin boat. Ive been using arjay pourable composite and love...
Power steeting pump pressure....a conundrum. So...my sbc engine has a v belt. My vw has a serpentine....what to do what to do. Should i just...
Yes. The hatch opening is at least 4ft by 4ft. The compartment is flush with cockpit floor
Ill 100% be using a closed loop systems. The only raw water in the system will be from raw water pump to heat exchanger to downpipe post turbo....
Engine: 2005 BHW VW 2.0 TDI Boat: 1988 citation 22ft 8 cabin boat Outdrive: volvo penta 290 Full electronic control. Throttle by wire. Malone...
Arjay is a competitor of seacast. Arjay and seacast have all been used for over a decade for transom and stinger repair/building with good...
I have an 88 citation, inboard aq211a, volvo penta 290(c?) 23 foot cabjn boat. While working on the tilt/trim issues i noticed a caved in motor...
Thank you so much! Would you recommend a different prop or would you use the same prop?
Hey guys. Im yanking a 350 for a 2.0 vw tdi. Im using the alpha outdrive. I currently have the 1.47 gear ratio leg Boat weighs 5400 lbs 26 ft...
Agreed 100% however for trial and error purposes the alpha makes better sense. Youll spend weeks looking for a spare used bravo vs the 20 on...
Is there any issue in running one of the cheap ebay water to air intercooler with a zink in the system? I need an intercooler on mine and was...
I hope you guys wont mind me jumping in on the subject. Ive seen a 1.9 vw tdi marinized. He works for some metal foundry and cast his own water...
I don't have any experience with the 420 but have put countless hours of research into marinizing vw and mercedes diesels. I'm in the need of a...
I simplified the thread to maybe get a few opinions
A few questions regarding a diesel conversion. 78 carver santa cruz 2567. 21 ft loa. 8 ft wide. Modified v hull approx 5500 lbs Im using a 2.0...