Update: - did sandpaper the transom - did sandpaper the fiber left and right of the inside. Not the centre because I doubt to pull some fiber out...
I think it going to take western red cedar for the new stringers. Now today I was cleaning the wind shelf. Does someone know which product you...
Yes that's true, but the old tabbing isn't that straight layed. But if it can avoid tha extra work... The tabbing that isn't fastened that good in...
Yes i some shops I do, but not the length I need (3m10). Is this the standard you need as stringer (18 or 19mm?) Thanks
Hello, update about the stringers wood choice: - Padoek also written padouk/padauk (first choice, expensive!!) - sipo wood (?) - cambara (?) Just...
what you mean with bad spots, white spots or delaminated areas? My plan was to sandpaper the whole inside (below sole) of the boat and then treat...
or using LVL?
And about the stringers, would it be a solution using seacast instead of wood? Because the wood will also rotten after some years?
Many thanks PAR and Mr efficiency!!!!!:);)
Today everything cleaned, all the foam remover from the fiber. What should I do with the fiber that is not placed good? You see some space under...
I think to do the next jobs in this organisation: - first to clean everything, the other foam at the FB where the stringer sat. - clean the parts...
The middle stringer is die 3/4 cut out. The back part was rotten, the other was good. Now I 'm gonna clean it between the FB where the stringer...
Which type of wood should I use for replacing the stringers? What's do you recommend?
One stringer was rotten about 40cm. The ohter part and the other stringer was not bad, but you see where the wood was wet or have been wet. I...
Hello, Did some work today. I pulled 2 stringers out and it went really easy. Thnx me efficiency for the advice!!! I tool the top of the...
I have 2 worries: 1) after replacing the stringers, what if the strength of the boat is not good? If it is wrong replaced you get cracks in the...
So you wouldn't take out the whole stringer, is this what you mean? I was thinking also to cut out the wet part till the wood is normal and dry...
Hahaha indeed, a sole in bitter and french fries! Did today the other part of the transom. It is ready to polish it. The front part of the...
I think I'm almost on the fiber, when i'm rubbing it with the chisel, it feels hard and not soft of the wood. About the deck, my question is, I...
Thanks for all the tips. Today I worked again at the transom, In almost get done. I used a cutter knife for the last layer of wood, and afterwards...
