So I need some advice from you guys! My plan is to build two seats on my aft deck that extends outside the deck and hangs over the water The aft...
Im planning new installation of a below deck furler but need to make a new chainplate for the forestay...but cant have any chainplate mounted in...
I'm planning to paint the floor inside my boat with a 2 component paint, single stage. The floor will be painted with a white color 2 inches wide...
If mixing epoxy resin and silica...rolling it out so it gets a texture.....when do u paint it with polyurethane? When it is gelling or let it cure...
Have been thinking about to remove my saildrive and engine from the boat (46 ft sailing trimaran) and replace with outboard. At the moment engine...
I MIGHT have added too little wax in the gelcoat. It feels 90% good. Not really tacky...but not perfect. Can I use a regular wax on top l...and it...
I'm building new countertops at the moment. If I apply non waxed polyester resin....will it cure when I pour the epoxy on top even if it is days...
I'm looking into getting a below deck installed head fuller...and now just trying to see if I have space for it without having to rebuild the...
Would pink foam be alright for ...a countertop? ... a berth? The supply is not very good here in Central America
The interior has been painted with a latex paint before. I have sanded all the area very good. ...but paint what shall I use this time? I'm not a...
Need to make a flat surface om my bulkheads. Some are because of veneer that has come loose. The remaing veneer seem to sit good. Other dents are...
Today I wanted to check my rudder in the top, around the rudder shaft. I cut out a small piece and see it seems to made with a wood core. The wood...
The boat is under a major refit in Mexico (so yes, supplies and what needs to be found are limited). The exterior is more or less done and on the...
So, on my 44ft trimaran, there is a plywood stringer that goes in the center of the boat with same height as the bulkheads the sole is resting at....
I have a daggerboard in the mainhull of my 44ft trimaran. So far I have not been sailing the boat, but been rebuilding it for a year so far....
I have some high moisture readings on some wood on my boat. It's the cross beam. Might be Douglas 6" x 2" Readings are 40-50%. Wood looks ok, not...
Sorry, I mean the traveler... I'm right now renovating and refitting a 46ft performance cruising trimaran. The mainsail traveler is a huge curved...
I plan to make a curved beam to have in the aft of my trimaran to hold an aft trampoline. One way would be to use foam and put about five layers...
After sanding I still have some low spots. Would prefer to not sand to much of the fiberglass. If I put filler would that be a bad way to go...
I will have my boat painted soon. Was thinking going with Interlux Interthane, white. To add som more live into the boat I would like to have some...