I will have to split into a few questions, since I have obvious technical question, but also some additional, let's say ecological question: 1....
Is it possible to use welded metal belows for sterndrives, if custom one could be built to replace the existing one? Could that be a "permanent"...
Hi all, I think I am in the right topic category (design), please, correct me if not. It is about functionality and estetics of the above water...
Hello, 1. Does anyone uses no feedback mechanical steering on the stern drive and what experience you have with it? How reliable it is? 2....
I need to reinstall the transom (gimbal) housing for the sterndrive (SternPowr model 103). On initial installation I could not find original...
Well, the whole question is in the title? I am asking this because I would like to know if it has sense to buy a couple of them for spare which...
I would appreciate if you could help me identify material of all layers in my hull, I am aware of some and guessing on others. Here is the photo...
As recommended by one forum member, I am linking here my thread from powerboats to get the answer which is actually about propulsion, maybe some...
At first, I will explain how I measure the fuel consumption, because maybe I am mistaking there, but not seeing it. When the fuel tank was new...
Well, I hope I have chosen good place in forum to ask this question. During the restoration/renovation planning of my boat, long time ago, my...
Hello, I have disassembled valve body of Prestolite trim pump (type without control valve and without manual release valve), and I know most of...
Hello, this is my first post on this forum, but I was reading it for quite some time and it was very useful when I needed some technical...