Interesting, as I am having the hull build in Malaysia as well, and in the process of fitting out, that is easier to have fitting out process made...
I have seen the video before, and not sure what they used to hold the hull, but then again, it is a very light cruising/racing type of hull as was...
I have 2 gantries as I have to have clearance bow and stern, but I lift from the bow side to flip, it was a wood composite boat so I can't have a...
Very interesting, was that a hydraulic jack? I've seen most use a pulley system for larger boats, but not ideal as the turn can be abrupt and...
Hello, I have read that there are people using aluthane successfully as protective coating on wood, as a primer on aluminum hull and protecting...
What you say is true, I believe it can't be changed the way at the price point and performance risk had to be accepted. At this stage it is a...
The image are generated image/design prompt for the project, run by a guy named Tony Ho, only the hull, exterior and mechanical are completed and...
Hello, I encounter this boat project with hull, structure, exterior, engine and everything almost complete except the interior had not been done....
Yes, the gantry is chain fall hoist, the engine crane is of telescopic boom that lifts up to 2.36m according to the manual with a range of 1-1.6m....
I have a 2 ton engine crane and have access to a 2.5 ton gantry crane, have anyone use such crane to turn a hull? On a seperate question, if both...
Finding people who can build in ferrocement today is tough enough. I talk to the only one I knew in Jiangsu who build concrete boats for 3...
Looking at a rusting large Buehler trawler on the market up for auction with no asking, think about it I would say I might if given there is...
I suspect the rust free basalt armature which I would use if I were to build today would cost even more than steel rods in the past too. And I...
The argument that there wasn't that much a reduction in cost is valid. But all other materials, be it wood, steel, aluminum is difficult to...
The Helsal I I read is a 70 feet yacht, and feom the work and and post-stress involved would be much too complicated boat for us to build and use....
I think using the canoe competition as an example would be too optimistic, ships or other boats that goes to sea for example uses more substantial...
I am reading this with interest as I am looking into basalt fibers and discovered basalt rod armature for ferrocement. Rust is a problem and will...
Unfortunately I won't be able to access to a supplier to ship for the smaller amount I would use in the region (Japan), so I would have to use...
There are good exterior grade ply and there are poor marine graded ply and they are not uniformly graded, and often times marine ply are...
Atkins have such a wide scope of design, say if one wanted to study their designs, which are the more refined of their characteristic designs? Say...