I have a 979917 Tru-Course steering and one of the two cables is starting to fray. are the cables replaceable, or is it a complete unit and has to...
I believe I'm going to use 3/4" Marine Ply, and treat it the best I can, It should last me my life time. Shipping can be a killer to NE Wisconsin.
I'm almost done with the demo part, I have a concern about the soaked foam that is below the 2' wide platform that is the floor for the fuel tank....
I just came by this boat, SS-235 22' Got the drive out engine to prop, now to tackle the wood rot. Stringers are junk from stern to the first step...
Ike,, Thanks for the Pic, Art
Will see what I can do about pics. I have a feeling someone went the cheap route and put a auto one on. Can not find a model # on it. I need to do...
Is there a way to tell a Marine alternator from an auto alternator by looking at it? Not sure what is on the engine I'm working on. It' a Delco-Remy.
Got it, wooden wedges, putty knives, brake cleaner, and being so careful, Thanks.
I have the fasteners off, it's the bond between the alum. frame and the fiberglass that's the real devil.
Anyone have helpful hints on getting my 1975 slickcrafts windshield off, Some of the bolts holding it on are rusted away, some are broke, the rest...
When you change the position of the offset you will also change the deck height of that piston, So you must have been running one deck height on...
After reading a ton about offsets, the main reason for the offset is to let the rod have a slight angle of attack when the power stroke starts so...
Working with a Chevy 307 (1975 Slickcraft) Seloc Manual says " The notch in the piston MUST face forward for the right bank, and face aft for the...
Looking to match the original cam, lift, duration, Lobe separation The cam specs.
Does anyone know the cam specs. of the OMC 225hp ( Chevy 307) ? Been looking but can't find the original specs. any place. Thanks,
Thanks,, found a 307 I think I can work with.
One more, This boat has the OMC elec. shift stringer drive. The Seloc book says to unbolt the bell housing and mounting bolts and move engine 6"...
"The 307 is a 153 tooth flywheel, with a straight across starter bolt pattern, while the 350 is a 168 tooth gear and the starter has diagonal...
Par, I was asking if the coupler that bolts to the 307 flywheel, will bolt on the flywheel of the 305 or 350. 2nd if I pick up a 305 or 350 with a...
Any engine I get will be pulled apart and get new bearings, rings, lifters, and if needed bored with new pistons, Couldn't just get one and drop...