well I think I did put a little less hardner the last batch..And I have decided that I need to put sheet metal over that area no mater how hard it...
i PUT THE LAST COAT OF EPOXY on last night and kept it up to 95 degrees for at least five hours....but it was still sticky...I thought I was going...
I could not understand your dis like of Varathane, until after you indicated that you thought it was an acrylic.....the varathane I have is an...
I am not getting enough information.....it maybe a comedy to some people but to me it is hell...... I discovered that oil based enamel does not...
ok I will have to get polyurethane.( any special kind?)....and forget the varathane. I was delayed yet another day, the epoxy on the strand...
so now I am going to apply the last of the epoxy tomorrow morning and after that drys I must apply the varathane ( it has a bit of aluminum powder...
the thing I am worrying about now is fumes after the epoxy cures....well if I can't small it , I hope it is not going to be bad enough to hurt me...
how exacting does the measure of the epoxy have to be... I went a little over the with the resin and tryed to adjust for the hardener....probably...
I am sure it will put out toxic fumes until it is dry to the touch... but there is no other way to keep the floor from rusting away completely....
The Ospho is on what is left of my metal sub-floor. And it looks like I will have to remove some of it at least the waxy part. actually it is...
OK I got the cheaper CDX looks ok to me. I need to know if the epoxy has any difficulty in drying? I have one piece of wood that has a...
I am going to a different lumber yard tomorrow, and they will be glad to sell me something more expensive... but ai do not need a better surface,...
OK I went tot he lumber yard today....and they said they have CDX for exterior plywood. It has nothing about the labels you showed me. The dolts...
OK I will find it....thanks! I do not live near a lowes or home depot.
well thanks, honey catches more flys.... well I hope this epoxy will do the job, I am ordering it today. I just hope 1.5 gallons will be enough......
ok I found the epoxy. How thick should it be applyed? 1/4 inch? will this stuff brush on? I was looking on the home-depot site for the "exterior...
terminal cancer of floor Is the exterior plywood you mentioned, marine grade plywood? that is about $130 a sheet. I was thinking it maybe...
maybe I should just not put anything on top of the ospho.....sound like the safest thing to do.
I was reading on another forum about how Ospho does leave a waxy film, that must be cleaned off with mineral spirits before applying oil based...
I have a gallon of Varathane with aluminum grit for floor durability, which I will use for the top of the particle board. And not use any liquid...
