PC 11, but its an old adhesive by now or West Systems G-Flex, but quite expensive I would think the surface prep would need to be meticulous...
Im not totally distressed at the idea, because on occasion we move forward a little in reviewing older methods. But I have some things for you to...
Good analysis of both existing and previous designs concludes that aircraft designed to be on the water such as flying boats are 1.25x heavier...
thats the case. When shipbuilding shifted from riveted to weldment structures as in liberty ships, the skill requirements where found to be less,...
I think this is among the most eloquent synopsis on the nature of the problem at hand. Much research has been committed to WIG sections as though...
In the same energy stream the force of suction is stronger than that of pressure, and we have seen that occur in several design endeavours. So it...
I think it varies from HarryProa by adding pressure on the leeward hull therefore increasing its displacement, where the HP will be tending to...
As it had such a long life the Lancaster went through many development types and engine fits, after all it began as the failed twin engine...
In the great speed battles of pylon racing era, aircraft of the day were still generally biplanes transitioning to monoplanes. This because as...
So there I was trusting my mind again, and getting it wrong. I looked up the MTO and empty weight, 68,000lbs and 36,900lbs for a disposable load...
just to allay any possible confusion, the folding Shark catamaran once featured in Wooden Boat I mentioned earlier was a Macalpine-Downie design...
one of the circumstances to conquer is getting it on and off the trailer if you have to do that all the time. As you are only trying to lose...
but not in Europe, where most 1940s development occurred. At the commencement of WW2 all RAF strips were grass field, most improvised Luftwaffe...
there is an interference drag with cat hulls, where the vectors of the wake interfere with each other. I dont know of any way to estimate it, just...
you can get leg extensions for outboards too, 5" - 10" just an example Im not recommending or affiliated with:...
Outboard cost? depends where you are, $5,000-$7,000 each, or around half an inboard install complete. Depending on capacity (weight) as large...
a 'sailing cat' yes not sure about topping up the tank at sea from gerry cans The possibility exists for a displacement cat designed to run on...
Direct therefore angled diesel drives lose 10% efficiency of power delivery, and you will need folding or feathering props or endure that drag...
oh Im sorry I didn't make the 12' and Under Trimarans-Ideas and Designs absolutely transparent, in that take the Idea, and make it a 12' or under...
WETA 4.4 is a tough concept to beat http://www.wetamarine.com/ [IMG]
