i plan on attaching with four bolts
so i go two holes up,that is 6cm higher than it is,i think bracket is cut off 34 cm,sharp eye mr efficiency,pad will be in place to even the...
i still have part wich is cut off,it would be easy fix to bond it back,but i hope it wont be necessary
so what about height of outboard [IMG] [IMG] [IMG] [IMG] how does it look?
there might be just enough place i check now and post
[IMG]its done [IMG] [IMG]
i will do like you draw mr,efficiency,but how should i line cavitation plate,looking at hull or what,i do understand the sea rises after it leave...
i know,but i will take better photo tomorrow.the repair guy is coming on monday
[IMG]here the trimm is all way down,towards the boat,when i put outboard level with boat it does come over ideal position cose bracket is lower
yea it did,but when i look from behind outboard the cavitation plate is litlle bit higher than bottom of the bracket,if cut in hull line it would...
i have two holes left to play with,what did i just wrote,but i think the shaft was already shorter than it should be
thanks i am trying to draw something and it came like this [IMG] do you think it would be enough to just do like your drawing,or i need to cut and...
why you think so,cose i thought cavitation plate should be in line with hull,no matter of bracket,so i thought to cut bracket and than just make...
so we are cutting bracket to a 12 or 14 degree angle upward,ill post pics of progress,so if someone have a better idea please tell before its too late
there was 5 bags,arund 200 kg,i took it out,but what now
well for me its definetly not about speed,but i wanna gain maximum bow lift,cose i think the water spray would be better directed away from boat,i...
but isnit obvious that pod angle is not correct,cose now the boat is out of sea and to try without and than work on pod i will need to already...
yea,in bags,and still is there,until tomorrow,if i only knew,i would took it out last summer,and not drive it around with me,blind passanger,talk...
today i did hear from previous owner and he told me he used a lot of quartz sand in a bow,to make boat bow heavy,when i asked why he couldnt...
so you say it should be cut to create 14* degrees upward