HI Does anyone know how to extract the Resistance value once the simulation is complete from Numeca Fine Marine? I am new to the software and...
Hi I am relatively new in Navcad. Can anyone provide me any tutorial link or explain how to do catamaran resistance analysis in Navcad. I am...
Yeah thats true. I also figured it out since F.Length calculation was running at very low displacement (mentioned above) & I was getting...
Hi TANSL I found out the solution for the problem. Its the Margin line . Since I have slopped transom so maxsurf somehow include the transom...
The only thing that I found out is that it works for small amount of displacement like 20 to 30 Tonne. But if the displacement is bigger which it...
The same error occurs with your given attachment too.
Hi In the criteria I set immersion criteria as Margin line immersion and also checked maximum trim angle, GMt and GMl criteria.
Hi I was trying to do floodable length calculations on hydromax. I did set Trim(LCG), VCG, Displacement range and criteria as shown in the...
Find the attached loading. Vessel particular: LOA=41m LBP=36m B=09m D=4.8 Draught=3.8
I was doing a Sever Wind and Rolling criteria calculation for a fissing vessel. But my vessel always fails. What is the remedy when a vessel fails...
Thanks for your reply. As far as I know no oil tanks are 100% filled because they leave space for oil expansion. But my question is I did not find...
Hello Everybody!! I was curious about the definition of the term "FULL LOAD CONDITION". In Intact stability code 2008 for cargo ship/Oil tanker it...
Thanks for your reply. I will definitely try to read that chapter.
Thanks for your reply. If I am getting you correctly then you are saying the shape of the tank works as a cap or blocker that prevents sudden...
Hye ! Everyone I am curious to know the reason why bulk carrier midship has top side hopper tank and Bottom hopper tank instead of conventional...
Thanks NavalSArtichoke and TANSL.
Thanks NavalSArtichoke. Now i have a pretty good idea where to start from. Though i have a question to ask why bottom damage is considered...
@TANSL thanks for your reply.Did you mean i should randomly damage one or two tanks and check the result to see what is the worst case ? Does...
Hello Everyone!! I want to know is there any specific reference about how create a damage case for damage stability analysis.I think just...