Search Results

Search Again
Page 1 of 2
  1. marsh trapper
    Post

    motor runs rough at 1/4 throttle and vibration and trouble startin

    got it Fixed it ..it was electric fuel pump going bad
    Post by: marsh trapper, Sep 1, 2015 in forum: Diesel Engines
  2. marsh trapper
    Thread

    motor runs rough at 1/4 throttle and vibration and trouble startin

    Hey guys I have a 3 cylinder beta28hp diesel inboard for my workboat at trotline crabbing speed about 1/4 throttle it vibrates horrible and it has...
    Thread by: marsh trapper, Aug 31, 2015, 2 replies, in forum: Diesel Engines
  3. marsh trapper
    Thread

    technodrive tmc 60 gearbox fluid check.?

    Hey all I have a phasor 28 hp marine diesel inboard with a technodrive transmission gearbox I believe its a tmc 60 or 40 twin disc....STUPID...
    Thread by: marsh trapper, Aug 26, 2015, 1 replies, in forum: Propulsion
  4. marsh trapper
    Thread

    Garmin 498 gps noob question

    Hey all I have a Garmin 498 on my boat and after doing a hard reset to the unit.. when start up unit and it acquires satellite s it shows a...
    Thread by: marsh trapper, Aug 2, 2015, 0 replies, in forum: OnBoard Electronics & Controls
  5. marsh trapper
    Post

    3 cylinder diesel exhaust leak problems

    Yes I just start it in let it run a few mins once or twice a weekand when I check oil followin week it that low
    Post by: marsh trapper, Jul 3, 2015 in forum: Diesel Engines
  6. marsh trapper
    Post

    3 cylinder diesel exhaust leak problems

    I think I may be good with the water, the water comes out past the gasket on top of the downward elbow for exhaust...about a half a quart that...
    Post by: marsh trapper, Jul 2, 2015 in forum: Diesel Engines
  7. marsh trapper
    Thread

    3 cylinder diesel exhaust leak problems

    Hey everyone I need help I have a 3 cylinder kubota diesel in my boat my fatheer was tryn to help me replacing the exhaust gasket at the manifold...
    Thread by: marsh trapper, Jul 1, 2015, 5 replies, in forum: Diesel Engines
  8. marsh trapper
    Post

    28 hp kubota inboard rough vibration

    And today checked oil for first time since buyin it and no oil at all (of course)..ughhh..and the previous owner said they took it out a few...
    Post by: marsh trapper, Jun 2, 2015 in forum: Diesel Engines
  9. marsh trapper
    Post

    28 hp kubota inboard rough vibration

    Further looking it it a phasor 28 hp (on a kubota block) and its a 3 cylinder ..
    Post by: marsh trapper, Jun 2, 2015 in forum: Diesel Engines
  10. marsh trapper
    Post

    28 hp kubota inboard rough vibration

    Thank u thats what I was thinking too .it vibrates rough in gear too I noticed yest ..of courrse the rpm gauge wont properly work...would I have...
    Post by: marsh trapper, May 31, 2015 in forum: Diesel Engines
  11. marsh trapper
    Thread

    any pics of deadrise workboats under 30 ft

    Thinking about a chesapeake bay deadrise workboat under 30 ft just want to see various styles
    Thread by: marsh trapper, May 31, 2015, 4 replies, in forum: Boatbuilding
  12. marsh trapper
    Post

    28 hp kubota inboard rough vibration

    I believe my motor is a beta 28
    Post by: marsh trapper, May 31, 2015 in forum: Diesel Engines
  13. marsh trapper
    Post

    28 hp kubota inboard rough vibration

    O and this rough vibration happens in neutral and n gear
    Post by: marsh trapper, May 27, 2015 in forum: Diesel Engines
  14. marsh trapper
    Post

    28 hp kubota inboard rough vibration

    Not sure what rpm is ill che k..and where is the idle screw
    Post by: marsh trapper, May 27, 2015 in forum: Diesel Engines
  15. marsh trapper
    Post

    28 hp kubota inboard rough vibration

    I just bought boat but guy said its always been like that...as soon as I bump it up some it smooths right out and is normal
    Post by: marsh trapper, May 26, 2015 in forum: Diesel Engines
  16. marsh trapper
    Thread

    28 hp kubota inboard rough vibration

    Hey guys I have a small deadrise workboat with a 28 hp kubota inboard 4 cylinder diesel that vibrates rough n really bad when throttle is all the...
    Thread by: marsh trapper, May 26, 2015, 11 replies, in forum: Diesel Engines
  17. marsh trapper
    Post

    commercial crossplanked deadrise workboat bottom compound caulkgun

    Is that what some people on forums reffer to as bear shi* ?
    Post by: marsh trapper, Feb 17, 2015 in forum: Wooden Boat Building and Restoration
  18. marsh trapper
    Post

    commercial crossplanked deadrise workboat bottom compound caulkgun

    What brand /type and did u use it before launch
    Post by: marsh trapper, Feb 17, 2015 in forum: Wooden Boat Building and Restoration
  19. marsh trapper
    Thread

    portland cement tar or other tar type forbottom seams

    What type do u guys use for your bottom seams I keep hearing portland cement but want to know any of u guys experience
    Thread by: marsh trapper, Feb 17, 2015, 0 replies, in forum: Wooden Boat Building and Restoration
  20. marsh trapper
    Post

    commercial crossplanked deadrise workboat bottom compound caulkgun

    What typ roofing tar or tar cement tho
    Post by: marsh trapper, Feb 17, 2015 in forum: Wooden Boat Building and Restoration
Showing results 1 to 20 of 21 Next >
Search Again
Page 1 of 2