I'll send you the DXF version. You'll need a CAD program that can open DXF files. There will be a very blotchy scan and another layer with...
The lines are in DXF format. In 2001, I left the original blueprints out in the sun for a week, and they were damaged. I then scanned them and...
As BobBill commented, this thread seem to refer to another thread or something. I'm interested in the topic, but a 1mm depression is pretty...
Again, my boat does NOT have Walt Scott's intended sail plan. Instead, the masts were "swapped," and the taller mast stepped forward in a Ketch...
As I recall, the masts were alum. flag poles. They are tapered, not welded. I'll get back with sail areas. That blade jib comes in if the wind...
My father worked on developing the Up-Right Hydrofoil kit, designed to be retrofitted to ~16' runabouts. It reached ~35 MPH on a ~30 HP outboard....
I sail hull #24: [IMG] The boat as designed was a schooner rig. My PO built the boat in MA from a "hull kit" and swapped main for mizzen (and...
Scuttle--small-ish hatch for access through the deck. No lighting effect unless it's open. [IMG]
An end plate is an excellent method to improve steering effectiveness in a shallow draft boat. Here in the Chesapeake, the average depth is 15...