Hello everyone, I am just finishing up a drift boat/ duck boat I built from scratch. I was wandering if anyone had any tricks on how to get a...
Hello all, I just built a fiberglass Drift boat with polyester resin. currently the floor is unsanded mat. What is the best additive to get a non...
Hello, Has anyone used the plascore honeycomb product? I am looking for a review. I am thinking of using it on the bottom of fiberglass/poly resin...
Hello all you fiberglass and boat design experts. My next question is how do I attach my seats and raised floor in my new drift boat I made from...
hello, I laid up two to three layers of csm. The first layer went down perfectly. The second and third however began to have small bubbles....
Hello, my question is how many layers of 1.5 0z should I make my mold? It is a 16 ft driftboat plug. How many layers can I apply at a time?
Hello everyone. I need some help, I am recoating my boat and cannot get my spray gun to shoot gelcoat well. It sprays a little but not much. The...
I have been designing a drift boat plug for the last 5 months and am getting close. I have been using fiberglass and bondo for the most part but...
Hello everyone, I am gearing completion of a drift boat plug and am wondering if there is any advice out there for me on layering my fiberglass...
I am wanting to use white hard board paneling 1/8 inch on a boat plug Im finishing, can I spray gelcoat on it? should I sand it first? Also the...
Hello All, I am nearly finished with my boat model and am starting to look into wax, pva, and tooling gel coat. I will be using the mold many...
Is there a quick, generic way to color Gel coat for a mold? I am wanting a red or orange color. there are no fiberglass retailers near and I was...