Thanks for all the answers. First, the engine fires up and runs perfectly with the original mallory flat cap single point and condenser. I have...
I replaced the coil and ballast on My chris craft 305K and I was wondering what the voltage should be at the coil with the engine running? I put...
Although I am not certain it is the tabs - It just seems too coincidental that it happened simultaneously - The boat has acted like this before...
This is a strange one...the engine has been performing great. On a recent run getting up on plane I used my Lenco trim tabs ( electric) for the...
Tapping Noise Thanks to all of you for your analysis. The tapping happens at idle and under load - but again, the performance and power are...
I have slight engine tapping/clicking noise in my 305 4 barrel engine. Recently tuned, with new plugs and wires, points/cap rotor, rebuilt carb....
I do run the blower and it helps - but this engine seems as though it wants more air when it goes throttle up...
-------------------------------------------------------------------------------- I have a 22 center console with a 350 marine power inboard....
I have a 22 center console with a 350 marine power inboard. The existing ventilation to the engine is two front facing air scoops and two facing...
I would change the oil, run it and check for any water. If it is a 4 barrell carb and it is exposed to high moisture and sits long enough you...
I have a 1979 305K chris craft engine with a flat cap mallory point distributor - super workhorse. However, I have recently had some trouble...
I will try to get some photos - the boat is a 22 fiberglass CC hull and liner, the liner is a separatep component made in a mold and attached to...
I want to cut in a storgage box (14x17x 9inch depth) for tools, etc on my 22 foot center console ( storage space is at a minimum). I am going to...
I have a 22 inboard and I am in the process of installing a 9.9 auxillary engine(90 lbs) on a new garelick outboard 4 stroke bracket. The bracket...
I am in the process of installing a 9.9 and have a question of where to the mount the bracket in relation to the prop/caviation plate depth. I...
kicker Thanks again, Do you think the the stock prop will work or should I look at a different size and pitch?
Kicker Thanks very much for the information - I was going to go with a 15hp to have adequate thrust but it sounds like the 9.9 is sufficient. Jim
I have a 22 foot center console inboard and I intend to get a kicker for auxiliary power. Does anyone have any experience or input in selecting a...
transom Nice post and nice work on the restoration. I am thinking of replacing an inboard CC to an outboard. I Cold you please describe how you...