Hi to you all. How can you expect the noise levels coming from a certain room in the vessel. for example, if i'm talking about a mess room or a...
Greatings I posted some time a go a question about designing the underdeck support for winch loads and poeple here were helpful enough to...
Greatings I posted some time a go a question about designing the underdeck support for winch loads and poeple here were helpful enough to guide...
i guess u are talking about an effective length of the plate here so how should i take this effective length? ur diagram cleared what u said...
then i will divide the load by the longitudinal stiffeners.for future designs u suggest designing with longitudinals and then solve buckling...
Petros: ur post is very helpful man. i just need to get clear on some stuff. if i'm having both longitudinal and transverse stiffener ,as in my...
AD Hoc: as u are an experienced member here I took another look at your thread. did u mean that i should neglect the plate and apply the loads to...
Sorry i didn't respond earlier i had a busy weak. hope u people are still around. TANSL: the bending stress in our case is the result of a...
the winch will pull a load of 40 tons it is relatively big
Tansl and Navalisartichoke: i know the plate alone will fail and i did mention in my first post that i'm designing the carling but i mentioned...
ad hoc: thanks but my problem is only in analyzing the bending stress in the deck plate caused by the winch moment. the earlier thread u posted...
Greatings every one I'm designing the carling for a winch that is to be fixed to a vessel's deck. the problem I'm facing is that the bending...
