Doesnt seem to be a bad hull, could it really go at 9 knots on 13 kW? The displacement comes at about 14 ton at 0,8 m draft as with the original...
I cannot seem to get rid of this particular leak point. When attempting to extrude the transom I cannot mark the lower edge yellow. :(
With the sailwing.
Ok figured it out, the arched deck needs to be done first and the transom afterwards. The deck gives the box some aesthethics back.
Yes. Bu t I think my mistake is to have the transom trapesoidal and then trying to project the curved deck over. You reckon this would be a...
Here is the net.
I have installed new version of delftship, just for fun. Nothing like it was so even though an easy model, this was bit of work.This is 12 m long,...
Direct shaft drive is very good idea as you can see, for you can scale both turbine and prop and be done with that. Hovever on boat with any sort...
Hello guys. I am looking for an independent boat surveyor in Netherlands. Could you navigate me to somebody reliable. Many thanks Jaro
facing the prop from behind the boat - that is what I meant. Imagine that I m standing behind the boat anf facing the stern.
Guys, if the shaft of my drive goes on the left side of the kayak , what direction must the propeller turn?
I see what you mean. Jaro
Shows this now: [IMG] Jaro
[IMG] Now transom vertical and the chine too more so.
[IMG] Resistance curve now looks like this. Am I doing something wrong or is this absurdly low?...
Well I m playing with it more, I might try to make transom vertical and see how it looks.
Many thanks, that is lots of reading. :) I have dropped the transom area since and the resistance figures go down.
O.K. I shall look into it, many thanks. Jaro
I know about bow, I thought that will be only dificulty, though there is a steelyard near which can bend most any plate shape. What do you mean...