You are right with the definition from the numeral 3.1.6; I personally think that 12217 may be confusing because everyone associate fully enclosed...
thank you all for your replies!! I thought I was missing something because in the H-4 ABYC standard I couldn't find an explicit mention to...
Hi everyone, I would like to ask you, regarding the H-4 ABYC standard, which variables you would consider in order to design a boat either quick...
As I told you before, I found this article "Dynamic stability of planing boats by Donald L. Blount and Louis T. Codega" from Marine Technology...
I'm sorry TANSL, I am not a native english speaker and I made a mistake writing the last comment. what I meant is that we made the inclining test...
Hello you all, I would like to ask you about what seakeeping/dynamic stability/maneuvering test you know for a planning hull boat with outboards....
Dear all, I have been reading this T&R Bulletin and I appreciate this wonderful job because it is very well explained. I have a question...
what do you think about the short courses Westlawn is offering? I was thinking about taking some courses which seem really interesting.
Thank you for your reply. That was what I tought, but I had to ask to be sure. Thank you again.
Dear all, Recently, I was reviewing the rules for building and classing High Speed Naval Craft 2015 from ABS, regarding the intact stability...
TANSL, you are right, I just didn't make myself clear. Certainly I'm talking about static trim, I haven't done a dynamic analysis yet.
Thank you for sharing your comments about this issue. I have estimate the weight and COG assuming full load capacity (ballast, fuel and...
Hello everyone, I would like to ask you about a problem I am having with a new product stability analysis. With the help of Orca3D I have...
Thank you again guys. As I said, I have done some research (I also went to the forum and asked you) and I passed my recommendations. Thank you...
The thing is we are building boats which are having extreme use. thus, we are having fatigue failures from 4 to 6 months.
You are quite right; However, I believe there are some local policies regarding those imports. That seems to be a job for the purchasing...
Thank you all, this has been very formative. We are exploring the aluminum market in my country in order to find the alloys you recommend... I am...
Thank you Ad Hoc, I will go through those articles and I will recommend to change the aluminum alloy. Regards.
Hello everyone, As I told you within my introduction thread, I recently joined a boat manufacturer company. I have learned a lot in these 3...
thank you both!! I will go through the links you posted here. TANSL, muchas gracias!!