So Han Solo and Chewbacca are in the cantina looking to blow off a little steam, In walks a Stormtrooper and Han gestures him to come over,...
I'm with Dave on this, Rabadak. There is a lot of value in using off the shelf and modular components and you are leveraging massive R&D budgets....
Thanks for the update Glad to hear of the successful conclusion. I would also like to offer thanks for sharing the results on the forum, it...
How easy would it be to add a second anti-syphon and dedicated fuel line - that would eliminate the harmonics/resonance in the system? Just a...
There are people who do, it is quite common to run the coolant through a calorifier/Hot water tank with a coil inside so the coolant doesn't mix...
Similarly, I pranked my supervisor by listing an occupational exposure limit for Hydrogen Hydroxide as 1.0 x 10^9 milligrams per cubic metre,...
I would call it George! ;)
I second that. Any special considerations when butchering? Was talking to a Farmer friend from the US and they have a major issue with wild...
Try looking for 'bilge pumps' and 'float switches'.
You could have a very small 'day tank' and when it runs out, sell them a refill - they're not paying passengers;- you're just an onboard gas...
Agreed, I think there needs to be some differentiation between privately owned and operated vessels and those which are professionally crewed....
It's taken a long time to establish the cause of the accident - during that time the dilemma is to 'refit' what could be a flawed design or write...
Please be specific;- Many surface drives have a fin on the shaft between the transom and prop, and steering is achieved by swinging the shaft...
Absolutely - another way to calculate would be to look at impulsive tensions - the momentary shock they would experience if a wave lifted the...
[IMG] http://www.vaccon.com/images/JW-PRIN.jpg Are these any good for this application - start about 20 bucks? Used to use them at Uni...
The SS may not be as 'mechanically' smooth as you imagine - a light polish to remove high spots might work wonders too.
Is the deck compromised in some way - if not, is it possible to simply plank on top of the existing deck (OK can't change the crown) but no cans...
If you are talking a sail-drive - choose a maker, e.g. volvo - pick the model and it will have it in the manual. for an inboard, with shaft and...
Seemed very quiet... Hmmm :!: :idea: I'd be tempted to shorten a couple of oars - leave only the bit from the handle to the rowlock and...
Whitepointers' posts are spot on. running out of fuel is a REALLY bad thing - there is all the debris, dirt, scale and water, not only from...