Hi Ryan I have recently started work on a design on a 5.8m alloy power cat using Freeship. It is possible. I tried 2 methods and the design a...
Freeship to Polycad Thanks for the replies. I don't have Rhino (yet) and Autocad proved problematic as (correct me if I am wrong) I needed to...
Polycad & bulkheads Now that the hull form is looking OK I thought it was time to start work on the bulkheads. Exported a dxf 3D mesh from...
Teach a man how to fish! Thank you all for the guidance - big results. Developablity is looking very good - a lot of green and very little red....
Real time tutorial Newhill You are on the money! Split the edges and add a new edge between the two new points/nodes and bingo back to...
Knuckle Hi Tansl Thanks for your suggestion, made perfect logic to me. I split both the shear and the chine between the bow and the first/last...
Hi Newhill Looks like you have been busy over your holiday. Look forward to seeing some more photos of your boat as it emerges through the door.:D
Cardboard model Friday night in AU. Given the medium used to make up a quick cardboard model I would have to say that the results are very...
Thank you Ok Lots of good advice. LP, I had a look at the other post you suggested. Going to need some more time to fully understand how...
Thanks Guys As this will be a one off for me, I guess the best bet is to make a scale model and check out how it pulls together. The idea...
Hi I am very new to this forum and am also trying to get my head around generating accurate development plates. I have just finished my first...