After a lot of research and thinking I have decided I need some type of anti siphon valve or anti vacuum check valve at the top of my headers....
I think I may be able to use the oil pressure switch to trigger a relay to turn on and off the pump. I have to do some testing to make sure, but...
I have been trying to find a way to have the pump run only while the engine is running but it is difficult. Injector wires seem to just have a...
For more vessel information, I don't know what all I can help with. I do not know what year or type it is, other than a guess of early 1960's...
Thank you all for the input. Should I raise the through hull portion to just above the water line, and hook the water pump up to the engine so it...
Ok, makes sense. When the pump is off though and the boat is just sitting in water, will it flood or only fill to the natural water line? If I put...
Here is a pic of the headers off the engine. [ATTACH]
Yes it is water cooled. I have a closed loop system for that. The water is injected at the low point of the exhaust manifold as shown in the pic.
[ATTACH] Here is a better sketch from the transom. Sorry the last one I drew in my truck in a parking lot. I am aware of the possibility of...
Would the water not just fill inside the header up to the height of the waterline, no matter where the tip exits the hull?
Hey guys, I am looking for some advise on a wet exhaust setup. I have a unknown 1960's fiberglass boat that I converted to jet drive, powered by a...